Specifications
|
Model |
KPS-PM100 | Profile System One Powered Mixer |
|
Output Power |
100W | 4 ohms @ 10% THD |
| 80W | 4 ohms @ 0.4% THD | |
|
Frequency Response |
20Hz-20kHz |
Actual response is tailored to speaker cabinet for |
|
Total Harmonic Distortion |
less than 0.4% | Measured at 1 VRMS (0dBv) at record output, effects send, or insert output |
| Hum & Noise | -115dB | Mic Input Rs=150 ohm, 20-20kHz |
| -52dB | Residual Noise, all level controls 0% (minimum) | |
| -50dB | Nominal System Noise, all level controls at 50% | |
|
System Gain |
All measurements made at 1kHz | |
|
77dB |
Mic to Power Amp Out (Ch 1 - Ch 4) |
|
| 57dB |
Line to Power Amp Out (Ch 1 - Ch 5) |
|
| 53dB |
Instrument to Power Amp (Ch 5) |
|
| 32dB |
Playback to Power Amp |
|
| 57dB |
Mic to Record Output |
|
| 44dB |
Mic to Effects Send |
|
| 52dB |
Mic to Insert Output |
|
| 25dB |
Insert Input to Power Amp Output |
|
|
Crosstalk |
80dB |
Channel to channel, 1kHz |
|
Input Channel Equalization |
Special curve that adjusts bass, mid, and treble frequencies | |
|
Master Equalization |
100Hz (Bass), 1kHz (Mid), 10kHz (Treble) all ± 12dB |
|
|
Digital Effects |
24 bit DSP, 8 effects; small room, large room, small
hall, large hall, chorus, chorus reverb, slap back (delay), echo |
|
|
Phantom Power |
+15V |
Applied to all Mic Inputs thru 3.3K resistors |
|
Footswitch |
Digital effects ON/OFF and Channel ON/OFF (playback remains active) | |
|
Power Requirements |
USA/Canada |
120VAC/60Hz, 100W nominal |
| Europe |
230VAC/50Hz, 100W nominal |
|
| UK |
230VAC/50Hz, 100W nominal |
|
| Australia |
240VAC/50Hz, 100W nominal |
|
| Japan |
100VAC/50-60Hz, 100W nominal |
|
|
Dimensions |
mm/kg |
326 (Height) x 226 (Width) x 270 (Depth), 8.2 kg |
| inches/pounds |
12 7/8 (Height) x 8 7/8 (Width) x 10 5/8 (Depth), 18.0 lbs |
|
|
Model |
KPS-LS100 | Profile System One Loudspeaker System |
|
Speaker Complement |
Low |
6.5" Wide-range cone speaker (2) |
| High |
Horn Piezo Tweeter, 2" x 6" |
|
|
Power Capacity |
50W |
Noise per EIA RS-426 |
| 100W |
Program power (music power) |
|
|
Frequency Response |
80Hz - 20kHz |
+/- 3dB when used with KPS-PM100 Amplifier |
|
Crossover Frequency |
5kHz |
Cone speaker operated full-range |
|
Nominal Impedance |
8 Ohms |
Accurate acoustical response |
|
Sensitivity |
94dB |
Measured 1Watt @ 1 meter |
|
Dimensions |
mm/kg |
485 (Height) x 226 (Width) x 270 (Depth), 8.2 kg |
| inches/pounds |
19 1/8 (Height) x 8 7/8 (Width) x 10 5/8 (Depth), 18.0 lbs |
|